AS 1562.1 PDF

March 26, 2020   |   by admin

Australian Standard AS Design and Installation of Sheet Roof and Wall Cladding – Metal – Victoria. Description. You will be required to comply with. AS – AS Design and installation of sheet roof and wall cladding Metal. Publication date: ; Original language: English. AS (R) Design and installation of sheet roof and wall cladding – Metal. View on Information Provider website {{ linkText }}. Abbreviation.

Author: Kagalkree Nitaxe
Country: Thailand
Language: English (Spanish)
Genre: History
Published (Last): 15 December 2014
Pages: 266
PDF File Size: 5.24 Mb
ePub File Size: 15.20 Mb
ISBN: 749-3-34786-359-9
Downloads: 79627
Price: Free* [*Free Regsitration Required]
Uploader: Karg

Metal battens shall be corrosion resistant and fixed to the. Where solar water heaters incorporating a roof storage.

Timber battens shall be sized and installed in accordance with AS AS — Steel Structures. Secure sarking at the top edge of the fascia and dress down 25mm into the gutter.

For slab on ground, use damp-proof course under wall frame bottom plates, to prevent corrosion The frame is to be permanently earthed. Use only sealants recommended by the manufacturer of.

Victorian Building Authority Opens in new window. Keep folded joints clear of valleys. Hole cutting or cutting of members should be done in 11562.1 way which does not leave swarf.

  FAVORIT 44010 PDF

It specifies requirements for the design and installation of all classes of self-supporting sheet metal roof and wall cladding for both cyclone and non-cyclone regions.

Channels should be clean of any swarf and mortar 15662.1. Where tiles abut a wall, turn the sarking neatly up behind. Contact Email, Phone and Address Details for this service in simple two column table format, header then data.

Use only sealants recommended by the manufacturer of the sheet material to be joined. Where battens are joined. Description You will be required to comply with this standard if you are a registered plumber, licensed plumber, or any other person authorised to carry out plumbing work, and you intend to undertake roofing stormwater work. Flashings shall be installed in accordance with part. Corrosion Protection The steel frame must be protected from corrosion in accordance with 3.

Metal roofing must be corrosion resistant in accordance with Table 3.

AS – Standards Australia

Where tiles abut a wall, turn the sarking neatly up behind flashing a minimum of 50mm. Metal roofing and accessories shall be installed. Where high front gutters are installed, attention is required.

Where one section of roof fully discharges onto. Roof tiles shall be fixed in accordance with the. Metal roofing must be corrosion resistant in accordance. AS — Roof tiles. Provide metal roofing as shown on the drawings.

  LEWIS COSER MASTERS OF SOCIOLOGICAL THOUGHT PDF

Standards Catalogue

Where different metals are. Ensure appropriate fall prevention requirements are. Australian Standard AS Hole cutting or cutting of members should be done in a. Metal battens are to be joined over trusses with a minimum lap of 40mm. Roof tiles shall be fixed in accordance with the BCA and referenced Standard and the nominated design wind speed for the project. The frame is to be permanently earthed. Roof battens may be of timber or steel. Electrical wiring, water pipes and other services passing through the frame are to be isolated from it by rubber grommets or other suitable material.

The requirement for sarking will be influenced by roof pitch, length of rafter and bushfire prone areas.